1/* SPDX-License-Identifier: GPL-2.0-only */
2/*
3 * Copyright (c) 2014-2016, The Linux Foundation. All rights reserved.
4 */
5
6#ifndef _UFS_QUIRKS_H_
7#define _UFS_QUIRKS_H_
8
9/* return true if s1 is a prefix of s2 */
10#define STR_PRFX_EQUAL(s1, s2) !strncmp(s1, s2, strlen(s1))
11
12#define UFS_ANY_VENDOR 0xFFFF
13#define UFS_ANY_MODEL "ANY_MODEL"
14
15#define UFS_VENDOR_MICRON 0x12C
16#define UFS_VENDOR_SAMSUNG 0x1CE
17#define UFS_VENDOR_SKHYNIX 0x1AD
18#define UFS_VENDOR_TOSHIBA 0x198
19#define UFS_VENDOR_WDC 0x145
20
21/**
22 * ufs_dev_quirk - ufs device quirk info
23 * @card: ufs card details
24 * @quirk: device quirk
25 */
26struct ufs_dev_quirk {
27 u16 wmanufacturerid;
28 const u8 *model;
29 unsigned int quirk;
30};
31
32/*
33 * Some vendor's UFS device sends back to back NACs for the DL data frames
34 * causing the host controller to raise the DFES error status. Sometimes
35 * such UFS devices send back to back NAC without waiting for new
36 * retransmitted DL frame from the host and in such cases it might be possible
37 * the Host UniPro goes into bad state without raising the DFES error
38 * interrupt. If this happens then all the pending commands would timeout
39 * only after respective SW command (which is generally too large).
40 *
41 * We can workaround such device behaviour like this:
42 * - As soon as SW sees the DL NAC error, it should schedule the error handler
43 * - Error handler would sleep for 50ms to see if there are any fatal errors
44 * raised by UFS controller.
45 * - If there are fatal errors then SW does normal error recovery.
46 * - If there are no fatal errors then SW sends the NOP command to device
47 * to check if link is alive.
48 * - If NOP command times out, SW does normal error recovery
49 * - If NOP command succeed, skip the error handling.
50 *
51 * If DL NAC error is seen multiple times with some vendor's UFS devices then
52 * enable this quirk to initiate quick error recovery and also silence related
53 * error logs to reduce spamming of kernel logs.
54 */
55#define UFS_DEVICE_QUIRK_RECOVERY_FROM_DL_NAC_ERRORS (1 << 2)
56
57/*
58 * Few Toshiba UFS device models advertise RX_MIN_ACTIVATETIME_CAPABILITY as
59 * 600us which may not be enough for reliable hibern8 exit hardware sequence
60 * from UFS device.
61 * To workaround this issue, host should set its PA_TACTIVATE time to 1ms even
62 * if device advertises RX_MIN_ACTIVATETIME_CAPABILITY less than 1ms.
63 */
64#define UFS_DEVICE_QUIRK_PA_TACTIVATE (1 << 4)
65
66/*
67 * It seems some UFS devices may keep drawing more than sleep current
68 * (atleast for 500us) from UFS rails (especially from VCCQ rail).
69 * To avoid this situation, add 2ms delay before putting these UFS
70 * rails in LPM mode.
71 */
72#define UFS_DEVICE_QUIRK_DELAY_BEFORE_LPM (1 << 6)
73
74/*
75 * Some UFS devices require host PA_TACTIVATE to be lower than device
76 * PA_TACTIVATE, enabling this quirk ensure this.
77 */
78#define UFS_DEVICE_QUIRK_HOST_PA_TACTIVATE (1 << 7)
79
80/*
81 * The max. value PA_SaveConfigTime is 250 (10us) but this is not enough for
82 * some vendors.
83 * Gear switch from PWM to HS may fail even with this max. PA_SaveConfigTime.
84 * Gear switch can be issued by host controller as an error recovery and any
85 * software delay will not help on this case so we need to increase
86 * PA_SaveConfigTime to >32us as per vendor recommendation.
87 */
88#define UFS_DEVICE_QUIRK_HOST_PA_SAVECONFIGTIME (1 << 8)
89
90/*
91 * Some UFS devices require VS_DebugSaveConfigTime is 0x10,
92 * enabling this quirk ensure this.
93 */
94#define UFS_DEVICE_QUIRK_HOST_VS_DEBUGSAVECONFIGTIME (1 << 9)
95
96/*
97 * Some pre-3.1 UFS devices can support extended features by upgrading
98 * the firmware. Enable this quirk to make UFS core driver probe and enable
99 * supported features on such devices.
100 */
101#define UFS_DEVICE_QUIRK_SUPPORT_EXTENDED_FEATURES (1 << 10)
102
103/*
104 * Some UFS devices require delay after VCC power rail is turned-off.
105 * Enable this quirk to introduce 5ms delays after VCC power-off during
106 * suspend flow.
107 */
108#define UFS_DEVICE_QUIRK_DELAY_AFTER_LPM (1 << 11)
109
110#endif /* UFS_QUIRKS_H_ */
111

source code of linux/include/ufs/ufs_quirks.h