| 1 | /* SPDX-License-Identifier: GPL-2.0 */ |
| 2 | /* |
| 3 | * xHCI host controller driver |
| 4 | * |
| 5 | * Copyright (C) 2008 Intel Corp. |
| 6 | * |
| 7 | * Author: Sarah Sharp |
| 8 | * Some code borrowed from the Linux EHCI driver. |
| 9 | */ |
| 10 | |
| 11 | /* HC should halt within 16 ms, but use 32 ms as some hosts take longer */ |
| 12 | #define XHCI_MAX_HALT_USEC (32 * 1000) |
| 13 | /* HC not running - set to 1 when run/stop bit is cleared. */ |
| 14 | #define XHCI_STS_HALT (1<<0) |
| 15 | |
| 16 | /* HCCPARAMS offset from PCI base address */ |
| 17 | #define XHCI_HCC_PARAMS_OFFSET 0x10 |
| 18 | /* HCCPARAMS contains the first extended capability pointer */ |
| 19 | #define XHCI_HCC_EXT_CAPS(p) (((p)>>16)&0xffff) |
| 20 | |
| 21 | /* Command and Status registers offset from the Operational Registers address */ |
| 22 | #define XHCI_CMD_OFFSET 0x00 |
| 23 | #define XHCI_STS_OFFSET 0x04 |
| 24 | |
| 25 | #define XHCI_MAX_EXT_CAPS 50 |
| 26 | |
| 27 | /* Capability Register */ |
| 28 | /* bits 7:0 - how long is the Capabilities register */ |
| 29 | #define XHCI_HC_LENGTH(p) (((p)>>00)&0x00ff) |
| 30 | |
| 31 | /* Extended capability register fields */ |
| 32 | #define XHCI_EXT_CAPS_ID(p) (((p)>>0)&0xff) |
| 33 | #define XHCI_EXT_CAPS_NEXT(p) (((p)>>8)&0xff) |
| 34 | #define XHCI_EXT_CAPS_VAL(p) ((p)>>16) |
| 35 | /* Extended capability IDs - ID 0 reserved */ |
| 36 | #define XHCI_EXT_CAPS_LEGACY 1 |
| 37 | #define XHCI_EXT_CAPS_PROTOCOL 2 |
| 38 | #define XHCI_EXT_CAPS_PM 3 |
| 39 | #define XHCI_EXT_CAPS_VIRT 4 |
| 40 | #define XHCI_EXT_CAPS_ROUTE 5 |
| 41 | /* IDs 6-9 reserved */ |
| 42 | #define XHCI_EXT_CAPS_DEBUG 10 |
| 43 | /* Vendor caps */ |
| 44 | #define XHCI_EXT_CAPS_VENDOR_INTEL 192 |
| 45 | #define XHCI_EXT_CAPS_INTEL_SPR_SHADOW 206 |
| 46 | /* USB Legacy Support Capability - section 7.1.1 */ |
| 47 | #define XHCI_HC_BIOS_OWNED (1 << 16) |
| 48 | #define XHCI_HC_OS_OWNED (1 << 24) |
| 49 | |
| 50 | /* USB Legacy Support Capability - section 7.1.1 */ |
| 51 | /* Add this offset, plus the value of xECP in HCCPARAMS to the base address */ |
| 52 | #define XHCI_LEGACY_SUPPORT_OFFSET (0x00) |
| 53 | |
| 54 | /* USB Legacy Support Control and Status Register - section 7.1.2 */ |
| 55 | /* Add this offset, plus the value of xECP in HCCPARAMS to the base address */ |
| 56 | #define XHCI_LEGACY_CONTROL_OFFSET (0x04) |
| 57 | /* bits 1:3, 5:12, and 17:19 need to be preserved; bits 21:28 should be zero */ |
| 58 | #define XHCI_LEGACY_DISABLE_SMI ((0x7 << 1) + (0xff << 5) + (0x7 << 17)) |
| 59 | #define XHCI_LEGACY_SMI_EVENTS (0x7 << 29) |
| 60 | |
| 61 | /* USB 2.0 xHCI 0.96 L1C capability - section 7.2.2.1.3.2 */ |
| 62 | #define XHCI_L1C (1 << 16) |
| 63 | |
| 64 | /* USB 2.0 xHCI 1.0 hardware LMP capability - section 7.2.2.1.3.2 */ |
| 65 | #define XHCI_HLC (1 << 19) |
| 66 | #define XHCI_BLC (1 << 20) |
| 67 | |
| 68 | /* Intel SPR shadow capability */ |
| 69 | #define XHCI_INTEL_SPR_ESS_PORT_OFFSET 0x8ac4 /* SuperSpeed port control */ |
| 70 | #define XHCI_INTEL_SPR_TUNEN BIT(4) /* Tunnel mode enabled */ |
| 71 | |
| 72 | /* command register values to disable interrupts and halt the HC */ |
| 73 | /* start/stop HC execution - do not write unless HC is halted*/ |
| 74 | #define XHCI_CMD_RUN (1 << 0) |
| 75 | /* Event Interrupt Enable - get irq when EINT bit is set in USBSTS register */ |
| 76 | #define XHCI_CMD_EIE (1 << 2) |
| 77 | /* Host System Error Interrupt Enable - get irq when HSEIE bit set in USBSTS */ |
| 78 | #define XHCI_CMD_HSEIE (1 << 3) |
| 79 | /* Enable Wrap Event - '1' means xHC generates an event when MFINDEX wraps. */ |
| 80 | #define XHCI_CMD_EWE (1 << 10) |
| 81 | |
| 82 | #define XHCI_IRQS (XHCI_CMD_EIE | XHCI_CMD_HSEIE | XHCI_CMD_EWE) |
| 83 | |
| 84 | /* true: Controller Not Ready to accept doorbell or op reg writes after reset */ |
| 85 | #define XHCI_STS_CNR (1 << 11) |
| 86 | |
| 87 | /** |
| 88 | * struct xhci_protocol_caps |
| 89 | * @revision: major revision, minor revision, capability ID, |
| 90 | * and next capability pointer. |
| 91 | * @name_string: Four ASCII characters to say which spec this xHC |
| 92 | * follows, typically "USB ". |
| 93 | * @port_info: Port offset, count, and protocol-defined information. |
| 94 | */ |
| 95 | struct xhci_protocol_caps { |
| 96 | u32 revision; |
| 97 | u32 name_string; |
| 98 | u32 port_info; |
| 99 | }; |
| 100 | |
| 101 | #define XHCI_EXT_PORT_MAJOR(x) (((x) >> 24) & 0xff) |
| 102 | #define XHCI_EXT_PORT_MINOR(x) (((x) >> 16) & 0xff) |
| 103 | #define XHCI_EXT_PORT_PSIC(x) (((x) >> 28) & 0x0f) |
| 104 | #define XHCI_EXT_PORT_OFF(x) ((x) & 0xff) |
| 105 | #define XHCI_EXT_PORT_COUNT(x) (((x) >> 8) & 0xff) |
| 106 | |
| 107 | #define XHCI_EXT_PORT_PSIV(x) (((x) >> 0) & 0x0f) |
| 108 | #define XHCI_EXT_PORT_PSIE(x) (((x) >> 4) & 0x03) |
| 109 | #define XHCI_EXT_PORT_PLT(x) (((x) >> 6) & 0x03) |
| 110 | #define XHCI_EXT_PORT_PFD(x) (((x) >> 8) & 0x01) |
| 111 | #define XHCI_EXT_PORT_LP(x) (((x) >> 14) & 0x03) |
| 112 | #define XHCI_EXT_PORT_PSIM(x) (((x) >> 16) & 0xffff) |
| 113 | |
| 114 | #include <linux/io.h> |
| 115 | |
| 116 | /** |
| 117 | * Find the offset of the extended capabilities with capability ID id. |
| 118 | * |
| 119 | * @base PCI MMIO registers base address. |
| 120 | * @start address at which to start looking, (0 or HCC_PARAMS to start at |
| 121 | * beginning of list) |
| 122 | * @id Extended capability ID to search for, or 0 for the next |
| 123 | * capability |
| 124 | * |
| 125 | * Returns the offset of the next matching extended capability structure. |
| 126 | * Some capabilities can occur several times, e.g., the XHCI_EXT_CAPS_PROTOCOL, |
| 127 | * and this provides a way to find them all. |
| 128 | */ |
| 129 | |
| 130 | static inline int xhci_find_next_ext_cap(void __iomem *base, u32 start, int id) |
| 131 | { |
| 132 | u32 val; |
| 133 | u32 next; |
| 134 | u32 offset; |
| 135 | |
| 136 | offset = start; |
| 137 | if (!start || start == XHCI_HCC_PARAMS_OFFSET) { |
| 138 | val = readl(addr: base + XHCI_HCC_PARAMS_OFFSET); |
| 139 | if (val == ~0) |
| 140 | return 0; |
| 141 | offset = XHCI_HCC_EXT_CAPS(val) << 2; |
| 142 | if (!offset) |
| 143 | return 0; |
| 144 | } |
| 145 | do { |
| 146 | val = readl(addr: base + offset); |
| 147 | if (val == ~0) |
| 148 | return 0; |
| 149 | if (offset != start && (id == 0 || XHCI_EXT_CAPS_ID(val) == id)) |
| 150 | return offset; |
| 151 | |
| 152 | next = XHCI_EXT_CAPS_NEXT(val); |
| 153 | offset += next << 2; |
| 154 | } while (next); |
| 155 | |
| 156 | return 0; |
| 157 | } |
| 158 | |